Coil trim spacers to suit Pajero Generation 3 & 4 rear upper 20mm lift pair KUN26 aluminium uvp Fully deburred

Fully deburred

similar strength to 4mm mild steel (250MPa) and 4mm stainless steel (205MPa)

lightest and best designed bash plates available

similar strength to 3mm mild steel (250MPa) and 3mm stainless steel (205MPa) and 6mm low grade Aluminium (105MPa)

and you don't want to change the coil stiffness

Coil trim spacers to suit Pajero Generation 3 & 4 rear upper 20mm lift pair KUN26 aluminium uvp Fully deburredPair of rear upper coil trim spacers to suit Pajero Generation 3 and 4, all variants. Spacers are 10mm thick which gives approximately 20mm of lift. Made in Australia. Machined from Aluminium alloy. Is the front of your Pajero too high for the rear, or is the rear too low for the front, and you don't want to change the coil stiffness? Are you going to load it extra heavy for a trip then want to put the suspension back to the way it is?