Crater Maker Dimple Die - 1/4" teaching we have come up with

we have come up with this solution

Dimensions for small tray are 15” long

therefore either some pre-stretching of the area may be required

Made with soft and lightweight cotton

This set includes the Rigid

Crater Maker Dimple Die - 1/4" teaching we have come up withThis is the best quality made in the USA dimple die available. Need to add a little bit of detail to your work? Drill or punch a 1 4 hole where you would like this detail then use either an impact hammer (air or cordless) or a hydraulic press to drive these dies together and form a unique "Crater" in your panel. These dimple dies are made from 4140 alloy steel and then hardened and tumbled for a smooth finish. Dimensions are 1. 5" diameter by